Aim The objective of this study was to evaluate the effect of abrasion wear on surface roughness and microhardness of different commercially available resin composites simulating pH-challenges of the oral cavity. Methods Three resin composites (RC) were used in this study: one conventional: Z250; and two bulk fill resin composites (BRC): Tetric N-Ceram (TNC) and Sonic Fill (SF). The RC was inserted in a prefabricated mold (15mm wide x 4mm thickness) in two layers, or in a single layer for BRC. Thirty samples were prepared and surface roughness (Ra) and Knoop microhardness (KHN) test were performed at three different time-points of evaluation: baseline (24h after sample preparation); partial (after pH cycling); and final (after simulated toothbrushing procedure). Two samples of each group were selected after different treatments and analyzed descriptively on a scanning electron microscopy (SEM). Data from Ra and KHN were analyzed by two-way repeated-measures ANOVA and Bonferroni’s post-hoc test with a significance level set at 5%. Results Ra increased for all groups (p<0.001), at the final time-point, Z250 and TNC groups present the highest values. Oppositely, KHN decreased for all groups (p<0.001), Z250 group showed the highest KHN values for all time-points (p<0.001). The SEM imagens showed a regular surface for samples cycled and irregular with inorganic particles exposed for samples toothbrushed. Conclusion pH-cycling and simulated toothbrushing affected the superficial properties (roughness and Knoop microhardness), as observed at SEM imagens, with irregular surface with inorganic particles exposure.

Abstract Objective: To compare the marginal degradation (susceptibility to marginal adaptation and marginal discoloration) of composite restorations placed in class II and V cavities using conventional and bulk-fill resin composites. Material and Methods: This study was approved by PROSPERO database (#42020201596). PubMed, Scopus, Embase, Web of Science, Lilacs, Cochrane, Open Grey, Clinical Trials, and Rebec databases were searched by three independent investigators using MeSH terms, supplementary concepts, synonyms, and free keywords, based on the PICOS strategy (P, population: restoration in permanent teeth; I, intervention: bulk-fill resin composite; C, comparison: conventional resin composite; O, outcome: marginal discoloration and adaptation; and S, study design: randomized and non-randomized clinical trials). The risk of bias was evaluated according to the Cochrane Collaboration’s tool, the meta-analyses by RevMan software, the certainty of evidence by the Grading of Recommendations Assessment, Development, and Evaluation, and the leave-one-out sensitivity test. The prevalence of successful events and the total number of restorations were used to calculate the risk difference at a confidence interval of 95%, according to a fixed-effect model. The heterogeneity was evaluated using the I2 index. Results: 16 from 10,780 studies were selected and included for qualitative and quantitative analysis. Two studies were considered as high risk of bias, one showing some concerns, and 13 as low risk of bias. Four meta-analyses evaluated the marginal adaptation and marginal discoloration in class II and V cavities, with a nonsignificant heterogeneity (I2 = 0%, p>0.05). The certainty of evidence was considered high, except for two subgroups of each outcome. Conclusion: There is evidence that composite restorations using conventional and bulk-fill resin composites present similar clinical performance related to marginal degradation.

Abstract: This in vitro study aimed to evaluate surface microhardness, roughness, color, gloss and topography of low-cost Brazilian resin composites, compared with an international one. All 120 samples (8mm ø x 2mm height) were prepared and divided into 5 groups: Ultrafill (Biodinâmica), Llis (FGM), Fill Magic (Coltene), Applic (Makira), and Filtek Z250XT (3M Oral Care). Surface microhardness (KHN) (n=10) was analyzed at two time periods: before and after simulated tooth brushing (STB). Other standardized samples of each group (n=10) were analyzed for surface roughness (Ra), color (ΔL, Δa, Δb, ΔE, ΔE00) and gloss unit (GU) at the same two periods. The topography of non-brushed and brushed samples of each group (n=4) was evaluated by scanning electron microscopy. Data were analyzed statistically by two-way repeated measures ANOVA with Bonferroni post-hoc test (KHN, Ra, GU), and one-way ANOVA with Tukey post-hoc test (ΔL, Δa, Δb, ΔE, ΔE00) (α=0.05). Topographic images were submitted to descriptive analysis. The low-cost Brazilian resin composites investigated were compared with the international one and revealed: lower KHN, regardless of before or after STB; statistically similar Ra before STB, except Ultrafill, which presented higher values; lower Ra after STB, except Ultrafill, which presented statistically similar values; statistically similar color change in ΔL, Δa, Δb parameters; statistically similar color change in ΔE, ΔE00 parameters, except Fill Magic, which presented lower values; lower gloss before STB; lower gloss after STB, except Ultrafill, which presented statistically similar values. In a situation of scarce resources, low-cost Brazilian composites might be an acceptable cost-effective restorative alternative.

Abstract: This study developed experimental gels containing titanium tetrafluoride (TiF4) combined with commercial 35% hydrogen peroxide (HP), and evaluated bleaching efficacy and pH of the gels, and mineral content and morphology of enamel submitted to these treatments. In phase-1, different stock gels mixed with TiF4 were combined with HP. In phase-2, the selected gels were tested on enamel/dentin specimens (n=8): HP; HP and Natrosol+TiF4 (HPnT); HP and Natrosol+Chemygel+TiF4 (HPncT); HP and Aristoflex+TiF4 (HPaT). Bleaching was performed in four sessions (3x15min-application/session). Color (CIEL*a*b*) and whiteness index (WID) were measured after each session, whereas whiteness index differences (ΔWID), color alteration (CIELab–ΔE, CIEDE2000-ΔE00), enamel morphology and pH, at end of bleaching therapy. The change in Knoop microhardness (ΔKHN) was compared before and after bleaching. Data were analyzed by two-way repeated measures ANOVA and Bonferroni (CIEL*, a*, b*), one-way ANOVA and Tukey (ΔWID, ΔE, ΔE00), and LSD (ΔKHN) tests (α=5%). SEM and pH measurements were submitted to descriptive analysis. No differences were observed in lightness (L*) or WID among the groups (p > 0.05), but HP exhibited lower b* values (p<0.05), higher ΔWID than HPnT, and the highest ΔE among the groups (p < 0.05). No differences in ΔE00 were observed between HP and HPncT (p > 0.05), and HPncT showed higher ΔKHN than HP (p < 0.05). HP presented pH values closer to neutral (6.9), whereas experimental agents showed acidic pH values (2.3–3.9). No morphological changes were observed in HP or HPncT groups. HPncT was able to bleach the enamel and maintain enamel microhardness and surface integrity, even at low pH.

INTRODUÇÃO: A remoção dos terceiros molares pode causar transtornos e prejuízos à qualidade de vida. OBJETIVO: Avaliar a qualidade de vida de pacientes submetidos à exodontia de terceiros molares, discutindo os eventos mais comumente observados. MATERIAL E MÉTODO: Sessenta pacientes de uma Clínica Privada de Cirurgia, da cidade de João Pessoa-PB, foram submetidos à exodontia de terceiros molares, pelo mesmo operador e em condições semelhantes. Os dados foram coletados em duas etapas: a primeira foi realizada no dia do procedimento, quando foram anotados os dados do paciente, assim como as informações relacionadas à cirurgia. A segunda etapa foi realizada sete dias após o procedimento, quando os pacientes responderam o formulário acerca da qualidade de vida durante o pós-operatório. RESULTADO: 71,4% dos pacientes submetidos a Osteotomia e Odontossecção mantiveram suas atividades normais, e 28,6% não mantiveram. No entanto, quanto aos pacientes não submetidos às técnicas, 40,9% mantiveram suas atividades normais e 59,1% não mantiveram. De acordo com a classificação de Pell & Gregory, percebeu-se que 71,4% dos pacientes Classe 3 mantiveram suas atividades sociais normalmente, enquanto 60% dos pacientes Posição C não as mantiveram. Dos pacientes que se isolaram socialmente e foram submetidos às técnicas, 71,4% relataram a dor como o principal motivo, e 100% dos pacientes Classe 3 e 80% dos pacientes Posição C optaram pela mesma resposta. CONCLUSÃO: Os resultados indicam que as técnicas empregadas no transoperatório não interferem na qualidade de vida do paciente durante o pós-operatório e a posição tem maior influência do que a classe, no que se refere ao desenvolvimento normal das atividades sociais.

INTRODUCTION: The removal of third molars can cause disorders and damage in quality of life. OBJECTIVE: This study aimed to evaluate the quality of life in patients underwent surgery, discussing the most commonly events observed. MATERIAL AND METHOD: Sixty patients of a private surgery clinic from João Pessoa/PB were underwent extraction of third molars by the same surgeon and and under the same conditions. Data were collected in two steps: the first one was accomplished at the day of the procedure, which were noted down both patient and surgery informations. The second step were realized seven days after the procedure, the patients answered a form about life quality at the postoperative period. RESULT: 71,4% patients underwent to osteotomy and odontosection maintained their normal activities and 28,6% did not. While in patients not submitted to the techniques, 40,9% maintained their normal activities and 59,1% did not. According to Pell & Gregory classification, 71,4% of patients Class 3 maintained normally their social activities, while 60% of patients Position C didn´t. Patients who remained socially isolated and were underwent to techniques, 71,4% reported as the main reason the pain, and 100% of patients Class 3 and 80% of patients Position C have chosen the same answer. CONCLUSION: The results suggest that the techniques used in the transoperative does not influence the quality of life during the postoperative and the position has more influence than the class, in respect to the development of normal social activities.